What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
14.06.2025 00:42

These are simplified answers to the original question, and does not change anything I wrote above.
so, what happens?
the problem then depends on "how fast does the fuse operate?".
What does a fuse do?
For this case there are devices called Metal oxide varistors (MOV).
2024–10–10[John johnson John Johnson ]
Are Turks ashamed of their Islamic heritage?
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
But it can get overloaded, and no longer works.
Upvotes:
There are two important concepts here.
2024–10–14 [Omar Gharbi Omar Gharbi ]
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
If Republicans say that Biden goes to shower with his daughter, how do Democrats support it?
At one ohm, the resistor has a maximum of 1 watt power.
This device then solves the entire problem.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
But… the neutral is now “floating” because of the 1 ohm resistance.
One is “what exactly is in a ‘surge protector’ ? ”
[image of Common-mode choke]
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
He then asserts :
Can you write a poem or short story based on the first image that shows up on Pinterest?
The other is “what does a “fuse” do?”
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
So, the voltage could go up to 500 volts, and the fuse will not open up.
This one hit behind the barn.
He then describes the function of a fuse.
What toxic behavior has been normalized by society?
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Have you experimented with bestiality?
Here is a simplified AC power diagram.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
6 Benefits of Beet Juice, Plus Nutrition and Risks - health.com
What is lightning?
[old diagram got deleted by accident]
2024–10–16 [ OO OLAOYE OYEBODE ]
A circuit breaker is similar, but is resettable.
First Sentence:
(Dc diagram shown, AC is similar).
How was your JEE Advanced 2024 result?
A fuse is a non-resetable over current circuit protector.
The MOV will conduct when the voltage exceeds 50% of line voltage.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
The bolt then partially travels down the line to your home.
An AC voltage/ current source, and an ac inductive load.
There are three different concepts here that are getting confused.
Should women be allowed in “combat roles” within the military?
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Because the load is inductive, the current lags the voltage.(by a bit).
In schematic diagrams this is the symbol for a fuse:
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
I post the exact comment here.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
a photo is worth a thousand words.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
This is where the MOV conducts again, and dissipated the energy.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
nine
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
eight
This is 'the assistant's answer'
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
At least they know the answer if they wanted it.
what exactly is a ‘surge’ protector?
It seems Mohan does not understand the difference between a comment and an Answer.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
One
Barnstars:
These devices are installed between the “hot” and “neutral” and protective ground.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
It also is a device that limits the change in current flow.
but I think this circuit , shows a few more pieces.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
He then describes Rainy Season and Lightning.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Now when you have a certain ac resistance, then a current flows in a loop.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
This is where this question deviates from being a 'generic' question, and becomes more specific.
Edit 2024–10.
but this device (an Inductor) … impedes the rapid changes in the current.
The third is lightning and “how it gets conducted into a home.”